IP Camera Troubleshoot
IP Camera Troubleshoot
I can not connect to the IP channel.
There are following possibilities:
Check the camera is online or not.
Check IP channel setup is right or not (...
Mon, 11 Apr, 2016 at 10:46 AM
After I connected to the IP channel, there one*window output is OK, but there is no multiple*window output.
There are following possibilities:
Chec...
Wed, 20 Apr, 2016 at 3:47 PM
After I connected to the IP channel, there multiple*window output is OK, but there is no one*window output.
There are following possibilities:
Check ...
Mon, 11 Apr, 2016 at 10:49 AM
After I connected to the IP channel, there is no video output in the one*window or the multiple*window mode. But I can see there is bit stream.
There are ...
Mon, 11 Apr, 2016 at 10:55 AM
My IPC is off line from time to time.
Check if the network environment is good and the network cable hole plug of IPC end is loose.
Check if there i...
Mon, 11 Apr, 2016 at 10:56 AM
What if network upgrade failed?
Log in again to check if upgrade is successful, because sometimes the progress bar doesn’t show feedback in time due to...
Mon, 11 Apr, 2016 at 11:20 AM
I can use “Ping” to test that the IPC is on line after upgrade, but fail to log in.
Possible reason: Check if the WEB port was modified.
Reset the de...
Mon, 11 Apr, 2016 at 11:21 AM
There is no code stream when I log in and the network program restarts constantly after upgrade.
Check if there is IP conflict or network disconnection...
Mon, 11 Apr, 2016 at 11:21 AM
There is no code stream when I log in and the network program restarts constantly after upgrade.
Check if there is IP conflict or network disconnection...
Mon, 11 Apr, 2016 at 11:21 AM
It displays “Resources are limited, failed to open video” after I log in the IPC.
Network bandwidth is not enough; change a switcher with bigger bandwi...
Mon, 11 Apr, 2016 at 11:24 AM